LMI messages are being sent on DLCI 0
اعتقد والله اعلم ان هذه الرساله ناتج Debug
وعموما سوف اجربها في لاب اللي بحضره للمجموعه الل بتخلص
بالنسبه للLMI هو عمليه الSignaling التي تستخدم في معرفه اي نوع يعمل بيه الFR Switch
ومنها بعد معرفه نوع السيجنالينج يقوم الروتر بأرسال رساله الي الFR Switch
يقوله يا سويتش انا عندي كام DLCI وما هي حالتهم فيقوم السويتش بالرد
ويتم الارسال علي DLCI 0 او 1023
وذلك سيظهر في الجزء الذي وجدته بالسرش
Status of Connections (LMI)
Each DLCI corresponds to a PVC (Permanent Virtual Circuit). It is sometimes necessary to transmit information about this connection (e.g., whether the interface is still active) the valid DLCIs for the interface and the status of each PVC.
This information is transmitted using the reserved DLCI 1023 or DLCI 0, depending on the standard used.
When a DTE device connects to a Frame switch, LMI advertises which DLCIs available to the DTE are active. LMI also changes a DLCI from a local (to a PVC) identifier to a global (entire network) one. This allows DTE device to be identified by DLCI, making a Frame network more like a regular LAN.
LMI monitors and reports on the status of PVCs. Any changes to the status of a PVC can be forwarded to other devices on the WAN. LMI multicast groups can be specified to multicast PVC and DLCI status updates. LMI uses reserved DLCI 1023 (cisco LMI) or DLCI 0 (ANSI and ITU).
وبذلك نعلم انه شغال Ansi او Q9331
شوف رابط سيسكو ده يا باشا وان شاء الله اكون وضحت لك الموضوع
https://www.cisco.com/en/US/tech/tk7...94183.shtml#t3
تحياتي اخي العزيز كل التحيه
لا تنساني من صالح دعائك
المفضلات