السلام عليكم
قوم بعمل Configuring Switches عن طريق برنامج Dynagen
وهذا هو config_options text
https://www.4shared.com/file/P_RGyoG...iguration.html
عبارة عن 2 سويتش (ٍS1 & S2) متوصلين بسويتش (Core)
وكتبت هذه command
S1(config-line)#int vlan 1
S1(config-if)#ip address 192.168.10.17 255.255.255.240
S1(config-if)#no shut
S1(config-if)#exit
S2(config-line)#int vlan 1
S2(config-if)#ip address 192.168.10.18 255.255.255.240
S2(config-if)#no shut
S2(config-if)#exit
لكن المشكلة فى الاتى لما بعمل ping
S2#ping 192.168.10.17
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.10.17, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5
عايز اعرف ليه النتيجة 5/0
مع ان النتيجة ظهرت فى الكتاب 4/5
وذلك لان
How can I ping through the core switch if I haven’t configured it yet ..you don’t need the switch configured to make it work. All ports are enabled by default, so by just turning it on you should be able to communicate between hostS
انا عايز اعرف الغلط عندى في ايه ليه نتجية الينج بتطلع 0
المفضلات