انا معرفش ال WLC ال Configuration بتاعته بتبقى ازاى انا اخدت عنه hint بس بسيط فى ال CCNP
اتمنى ال links دى تفيدك لحد ما حد يعطيك رد من الاعضاء
https://www.cisco.com/en/US/products...5cdf.shtml#wlc
https://www.cisco.com/en/US/tech/tk7...8070ba8f.shtml
وخلى بالك من الجزئية دى
Configure the Layer 2 Switch Port that Connects to the WLC as Trunk Port
You need to configure the switch port to support the multiple VLANs configured on the WLC because the WLC is connected to a Layer 2 switch. You must configure the switch port as an 802.1Q trunk port.
Each controller port connection is an 802.1Q trunk and should be configured as this on the neighbor switch. On Cisco switches, the native VLAN of an 802.1Q trunk, for example VLAN 1, is left untagged. Therefore, if you configure a controller's interface to use the native VLAN on a neighbor Cisco switch, make sure you configure the interface on the controller as untagged.
A zero value for the VLAN identifier (on the Controller > Interfaces window) means that the interface is untagged. In the example in this document, the AP-Manager and Management Interfaces are configured in the default untagged VLAN.
When a controller interface is set to a non-zero value, it should not be tagged to the native VLAN of the switch and the VLAN must be allowed on the switch. In this example, VLAN 60 is configured as the native VLAN on the switch port that connects to the controller.
ال configuration اللى هتبقى على ال MLS سهلة اللعب كله فى ال configurations بتاعة ال WLC
ويا ريت اما تظبط العملية دى تبقى تقولنا فى ال post دا ايه الاخبار والحل كان ازاى عشان نستفييييد :D
المفضلات