page:364 Q:25
This is the right answer
First of all you have to know the proccess ID by using show run
testking1>ena
testking1#show run
.................................................. ...........................
< output omitted >
no ip directed-broadcast
!
router ospf 2
log-adjacency-changes
network 192.168.15.0 0.0.0.255 area 0
network 192.168.161.4 0.0.0.255 area 1
--More--
.................................................. ............................
we notic two things
The proccess ID is 2 so we have to use the same proccess ID
The wild card mask and the area no. for network 192.168.161.4 is wrong
so lets continue
testking1#conf t
testking1(config)#router ospf 2
testking1(config-router)#no network 192.168.161.4 0.0.0.255 area 1
testking1(config-router)#network 192.168.161.4 0.0.0.3 area 0
ctrl-z
testking1#copy run start
page:372 Q:29 & page:375 Q:31 exactly the same steps
NOTE: There is no need to define the interfaces because the question say that the error is in routing table not in interfaces
NOTE: In page:367 Q:26 & page:368 Q:27 the question dosnt assign which router has the problem so you have to use
SHOW RUN command in all routes, in one of routers you will find the same problem above, continue the same steps
NOTE:There is no need to define ospf in all routers just the router that has a problem.
المفضلات