B - C. it will search for the configuration file on a TFTP server and if no configuration file is
found there, it will enter the setup dialog.
في سؤال مكرر مرتين وكل مرة اجابة
واريد من الشخص المتاكد من الاجابة الصحيحة ان يقول لي لاني بصراحة لست متاكد من الاجابة
السؤال يقول
What will a router do during startup if a configuration file is not located in
NVRAM?
B - C. it will search for the configuration file on a TFTP server and if no configuration file is
found there, it will enter the setup dialog.
D. it will search for the configuration file in flash and if no configuration file is found
there, it will load a limited configuration file from ROM.
اي من هاتين الاجابتين هي الصحيحة
الرجاء اريد الرد بسرعة لانو حاسس هذا السؤال راح يجيني بالامتحان
B - C. it will search for the configuration file on a TFTP server and if no configuration file is
found there, it will enter the setup dialog.
الحل هو
it will search for the configuration file on a TFTP server and if no configuration file is
found there, it will enter the setup dialog.
صديقى العزيز ان الاجابة الصحيحه هى
B - C. it will search for the configuration file on a TFTP server and if no configuration file is
found there, it will enter the setup dialog
ويسالك هذا setup mode
مجموعه من الاسئله لابد ان تجابو عليها حتى يستطيع ان يحمل وينشا من
من جديد configuration file
the answer is that the router will look in the flash before trying to look at the server side am 100% sure of this ... good luck
the router looks into Non-Volatile RAM (NVRAM) for the startup configuration file. If such a file is not found, and the router has not been programmed to look to a TFTP server for this file, the router enters setup mode.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]:
u dont need to answer "yes" to this question, becuase Setup Mode is a long. clumsy way to set up a router i think!!!.
So B-c is the correct one as it ends up with setup mode
المفضلات