الف مبروك وعقبال ال ccnp يارب
لكن لي سؤال بسيط عن الامتحان هل سؤال ال sw_Ac3 "اللي موجود في v.90" جه ولا لاء؟
شكرا جزيلا
والف مليون مبروك مره تانيه وعقبالنا كلنا يارب
معظم الاسالة كانت من TESTKING V90 وخصوصا VLAN
السؤال الذي قد شرحه زميلي من قبلي عن VALN اتى بنفس الصيغة ونفس الارقام
واجاني سؤال عن OSPF ومعظم و Drag and drop من testking بالضبط
بالتوفيق لمن يريد تقديم الامتحان
الف مبروك وعقبال ال ccnp يارب
لكن لي سؤال بسيط عن الامتحان هل سؤال ال sw_Ac3 "اللي موجود في v.90" جه ولا لاء؟
شكرا جزيلا
والف مليون مبروك مره تانيه وعقبالنا كلنا يارب
السؤال عن SW-Ac3 بالضبط هو نفسه اللي موجود ب v 90
بالتوفيق ان شاءالله
الف الف مبروك وعقبال ال ccnp يارب
ولكن ما هو (السؤال الذي قد شرحه زميلي من قبلي عن VALN اتى بنفس الصيغة ونفس الارقام)
وما هو OSPF الذى جاء لك فى الامتحان
الف مبروك
وفقك الله تعالى
[B][COLOR="blue"][CENTER]تكلم وأنت غاضب .. فستقول أعظم حديث تندم عليه طوال حياتك[/CENTER][/COLOR][/B]
الف مبروك وعقبال الccnp
شد حيلك
بالتوفيق
TaKe a Massive Step
بالنسبة لسؤال ال Vlan السؤال هو
وهذا الشرح الذي قدمه زميلي
الاخوة الاعزاء اشكركم على حسن مشاعركم
ويساعد على فهم السؤال بشكل كامل وشكرا له
اعتمدت على sybex 5 والتست كنج وخاصة الاصدار 89 كان معظم الاسئلة منه تحديدا الجزء الاخير
اما سؤال الاخ عن سؤال vlan+vtp
فان استخدام الاجابات التالية ومعها توضيح اوامر الاظهار المناسبة لكل حالة تفيد المطلوب
Q.1.What happens when SwX is reconnected to the network and a trunk exists between the two switches?
Step 1.Issue the Sw-AC3#show vtp status command.Note the domain name.The domain name of the 2 switches must be the same for them to
exchange vtp messages
Step2:If the domain name is the same,note the config rev no of Sw-AC3 and compare with that of Sw-X.Whichever switch has higher config
revision no. will be the vtp updater.Say Sw-X has higher rev no.Its vlan will replace that of Sw-AC3.
-----------------------------------------------------------------------------------------------------------------------------
Q2.What interface did switch AC-3 associate with Mac address 0010.5a0c.ffba?
Step1.Type in the command <SW-AC3#show mac-address-table.This will give you the port on which the MAC address was leant by this switch
-----------------------------------------------------------------------------------------------------------------------------
Q3.To which port of Sw-Ac3 is router VLAN-R1 connected?
Step1.Type <Sw-Ac3#show cdp neighbor detail.This will provide the details of VLAN-R1 i.e. hostname,IP address,and IOS version.
Step2:Type <Sw-AC3#cdp neighbor.This will display the port (local interface)on which R1 is connected.
-----------------------------------------------------------------------------------------------------------------------------
Q4.What ports of switch Sw-Ac3 are operationg as trunks?
Step 1.Type <Sw-Ac3#show interfaces trunk.This will display all the trunk ports.eg
Sw-AC3# show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 on 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-2
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-2
-----------------------------------------------------------------------------------------------------------------------------
Q5.Which switch is the root bridge?
Step1.Type <Sw-Ac3#show spanning-tree.This will give the MAC address of root bridge
Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)
Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2
----------------------------------------------------------------------------------------------------------------------------
Q6.out of which port on Sw-Ac3 will an IP packet with destination address not on local LAN be forwarded.
Step1.The packet will be sent to the default-gateway.Hence type <Sw-Ac3#show running-config.Note the IP address of the default-gateway.
Step2.Now type <Sw-AC3#show cdp neighbor detail.This will provide ip address mapping to hostname.
Step 3:Type <Sw-AC3#show cdp neighbor.This will give the local interface associated with the hostname.
-----------------------------------------------------------------------------------------------------------------------------
Q7.Which Which switch is the root bridge for vlan 1?
Step 1.Type <Sw-AC3#show spanning-tree vlan 1>This will give the MAC address of root bridge
Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)
Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2
-----------------------------------------------------------------------------------------------------------------------------
Q8.What address should be configured as the default-gateway for the host connected to
interface Fa0/4 of Sw-AC3?
Step1.Type <Sw-AC3#show vlan.This will display list of vlans and associated port.Based on the vlan no find out the default gateway (i.e
interface ip address of VLAN-R1 router corresponding to that vlan
-----------------------------------------------------------------------------------------------------------------------------
Q9. Out of which ports will frame with source mac-address 0010.5a0c.A086 and destination mac address 000a.8a47.0612 be forwarded (choose two)
Step1.Type <Sw-AC3# show mac-address-table.
Step2.In the output check if the 2 mac addresses mentioned above have been learnt by the switch.If they are not then it will be flooded out on
all ports except the port on which it was recd (the port coressponding to source mac).If dest mac is present in the table it will be sent out on
the port on which the address was learnt(port coresponding to the address in the output of show command)
-----------------------------------------------------------------------------------------------------------------------------
Q 10.From which switch did Sw-AC3 receive the VLAN information?
Step1.Type <Sw-AC3#show vtp status>
Step2.The VTP message contains updater identity i.e one who has last updated the vlan config info.The IP address of the updater will be
displayed at the bottom i.e the updater of vlan info along with the time when it updated.It could also be Sw-AC3 itself.In that case the
updater identity will indicate as local.
Step3.Now type <Sw-AC#show cdp neighbor detail.This will provide the hostname corressponding to that IP
اما بالنسبةلل OSPF
big compnay has implemented OSPF routing and they installed other new router but this router can't get connectivity to other routers
the probem is with the network and wildcard mask and should be in area 0 not area 1
السؤال موجود ب Testking V90
ألف مبروك وعقبال الدرجات العلى إنشاء الله
ألف مبارك أخي الكريم وإلى الأمام...
سؤال مهم: هل اعتمدت أي تعديلات على testking v90 قبل تقديم الامتحان أم أنك درست نفس الإصدار بدون تعديلات؟؟؟
وفقك الله
(z)
نعم اخي الكريم هناك بعض التعديلات بالاسالة وايضا زميلي وضع ملف خاص باصلاح الاسالة الخطأ في v90 واتاني سؤالين منهم
يجب الانتباه الى هذه النقطة
والله الف مبروووك اولا !Clap !Clap
وبعدين
ياريت تقول لنا كم عدد الاسئلة وكم عدد الاخطاء وبعدين تعيد
انا سمعت ان الاسئلة 60 سؤال 40 من التست كنغ و20 من برى تجواب غلط في 6 اسئلة تطلع اوت
هل هذا الكلام صحيح
عطر فمك ......بالصلاة على الرسول
صلى الله عليه وسلم
اللهم أعز الأسلام وانصر المسلمين
اللهم عليك باليهود الغاصبين
CCNA --------------> PASS
MCSE-----> IN PROGRESS
الف مبروك اخي وعقبال ccnp
اخي الكريم الامتحان كان بنسنة كم في المائة من التست كنغ
اخى rawad_g
هل من اللمكن توضيح السؤال رقم 9
Out of which ports will frame with source mac-address 0010.5a0c.A086 and destination mac address 000a.8a47.0612 be forwarded (choose two)
حيث اننى قرأتة عدة مرات ولم افهمة جيدا
وعندى استفسار اخر بالنسبة للسؤال 10
لو ان البيانات التى عندى كالتالى
2950sw3#show vtp status
VTP Version : 2
Configuration Revision : 2
Maximum VLANs supported locally : 64
Number of existing VLANs : 5
VTP Operating Mode : Server
VTP Domain Name : bigdomain
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0xEE 0xB3 0xDC 0x9F 0xE2 0xE0 0x25 0xDF
Configuration last modified by 0.0.0.0 at 3-1-93 04:55:57
Local updater ID is 0.0.0.0 (no valid interface found)
2950sw3#show cdp nei detail
-------------------------
Device ID: router3
Entry address(es):
IP address: 197.10.1.1
Platform: Boson 2501 , Capabilities: Router
Interface: Fas0/1, Port ID (outgoing port): Eth 0
Holdtime: 164 sec
Version :
Boson Operating System Software
Software, Version 12.1(16), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2001 by Systems, Inc.
Compiled Fri 02-Mar-01 17:34 by dchih
-------------------------
Device ID: 2950sw4
Entry address(es):
IP address: 197.10.1.100
Platform: Boson 2950 , Capabilities: Trans-Bridge Switch
Interface: Fas0/12, Port ID (outgoing port): Fas 0/12
Holdtime: 164 sec
Version :
Boson Operating System Software
Software, Version 12.1(16), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2001 by Systems, Inc.
Compiled Fri 02-Mar-01 17:34 by dchih
2950sw3#
فى هذة الحالة هو الذى يقوم بالـ update
شكر ا جزيلا لك امتحانى غدا ان شاء الله
المفضلات