وينكم يا مجتهدين؟ ما في أحد قدر يحل المشكل
السلام عليكم ورحمة الله
بعد أن عملت reset للروتر من boot-rom أعطاني رموز غريبة آسكي
من حصل له مثل هذا الأمر ؟
فقد احترت في امري
وصلى الله على نبينا محمد وعلى آله وصحبه
وينكم يا مجتهدين؟ ما في أحد قدر يحل المشكل
وصلى الله على نبينا محمد وعلى آله وصحبه
Try to open the chassis of the router and remove the RAM and the ROM and put them back. I had a similar case where my 2600 Router lost power during bootup and image decompression and POOF! every time i turn it on i can see "bullshit" characters!!! so the moral of the story is "NEVER turn off the router/switch during bootup or u will be in a deeeep shit!"0
Dear Brother
this is not a problem ,and so no need to fix any thing ,this happened with you because the speed of the communication was changed while you are at the boot-rom .
what to do is very simple
just try to open the Hyper terminal at a different speed than 9600 bit/sec,try all the speeds you have ,one of the speed will open ensallah the router.
then what you have to do is to change the speed of the communication back to 9600 from the config mode,and copy run start ....
thats all
if it didn't work please tell me
asabha@psut.edu.jo
ashraf
Cisco certified academic Instructor
السلام عليكم ورحمة الله
أخي osamoz الأمر يا اخي لو كان عاديا لما قلته ولكن الأمر تعدى إلى 2 روتر سيسكو 1760 وقد بقيت حوالي 5 ساعات مع الروتر لأحل المشكل فما انحل - بارك الله فيك وأجرك وحياك
أخي intel2000 حاولت أن أفتح الروتر عند أن كان المشكل لكني منعت من المسؤولين عنه فلم يبق لس إلى ما هو سوفت أي بدون فتح الروتر
أخي أشرف سأجرب هذه الطريقة إن شاء الله مع أنني متيقن أنني لا أتعامل مع الروتر إلى ب 9600 ب/ث والله المستعان
بارك الله فيكم إخواني جميعا
أخوكم عماد المغربي
وصلى الله على نبينا محمد وعلى آله وصحبه
thank brother ashraf
it's ok, i made it and i tried with 115200 and i reloaded a new flash from the cisco cd
now it's ok, the router is running on
thanks again for you and for all other brothers
وصلى الله على نبينا محمد وعلى آله وصحبه
welcome ya 3ammee
this is good
beltawfeeek
المفضلات