النتائج 1 إلى 8 من 8

الموضوع: سؤال 44 في p4s لاهل الخبرة

  1. #1
    عضو
    تاريخ التسجيل
    Oct 2006
    المشاركات
    122
    الدولة: Egypt
    معدل تقييم المستوى
    0

    سؤال 44 في p4s لاهل الخبرة

    السؤال ده تعبني بصراحة علي الاخر
    لو فيه حد عنده شرح ليه
    يارب يحطة هنا
    السؤال عن vtp simulation
    أرجو المساعدة امتحاني بعد بكرة

  2. #2
    عضو
    تاريخ التسجيل
    Sep 2005
    المشاركات
    58
    معدل تقييم المستوى
    0

    رد: سؤال 44 في p4s لاهل الخبرة

    اخي العزيز هذا السؤال لا ياتي في الوقت الحالي في الامتحان لانه سؤال قديم كان ياتي في السابق ولان لا ياتي

    ولكن علي العموم هذا الخطوات سوف تساعدك علي فهم السؤال
    وبالتوفيق ان شاء الله


    Q.1.What happens when SwX is reconnected to the network and a trunk exists between the two switches?
    Step 1.Issue the Sw-AC3#show vtp status command.Note the domain name.The domain name of the 2 switches must be the same for them to exchange vtp messages

    Step2:If the domain name is the same,note the config rev no of Sw-AC3 and compare with that of Sw-X.Whichever switch has higher config revision no. will be the vtp updater.Say Sw-X has higher rev no.Its vlan will replace that of Sw-AC3.
    -----------------------------------------------------------------------------------------------------------------------------
    Q2.What interface did switch AC-3 associate with Mac address 0010.5a0c.ffba?
    Step1.Type in the command <SW-AC3#show mac-address-table.This will give you the port on which the MAC address was leant by this switch

    -----------------------------------------------------------------------------------------------------------------------------
    Q3.To which port of Sw-Ac3 is router VLAN-R1 connected?
    Step1.Type <Sw-Ac3#show cdp neighbor detail.This will provide the details of VLAN-R1 i.e. hostname,IP address,and IOS version.
    Step2:Type <Sw-AC3#cdp neighbor.This will display the port (local interface)on which R1 is connected.

    -----------------------------------------------------------------------------------------------------------------------------
    Q4.What ports of switch Sw-Ac3 are operationg as trunks?
    Step 1.Type <Sw-Ac3#show interfaces trunk.This will display all the trunk ports.eg
    Sw-AC3# show interfaces trunk
    Port Mode Encapsulation Status Native vlan
    Fa0/1 on 802.1q trunking 1
    Port Vlans allowed on trunk
    Fa0/1 1-4094
    Port Vlans allowed and active in management domain
    Fa0/1 1-2
    Port Vlans in spanning tree forwarding state and not pruned
    Fa0/1 1-2


    -----------------------------------------------------------------------------------------------------------------------------
    Q5.Which switch is the root bridge?
    Step1.Type <Sw-Ac3#show spanning-tree.This will give the MAC address of root bridge

    Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)

    Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2

    ----------------------------------------------------------------------------------------------------------------------------
    Q6.out of which port on Sw-Ac3 will an IP packet with destination address not on local LAN be forwarded.

    Step1.The packet will be sent to the default-gateway.

    Step 2:Type <Sw-AC3#show cdp neighbor.This will give the local interface associated with the hostname of the router.

    -----------------------------------------------------------------------------------------------------------------------------

    Q7.Which Which switch is the root bridge for vlan 1?

    Step 1.Type <Sw-AC3#show spanning-tree vlan 1>This will give the MAC address of root bridge

    Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)

    Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2

    -----------------------------------------------------------------------------------------------------------------------------
    Q8.What address should be configured as the default-gateway for the host connected to
    interface Fa0/4 of Sw-AC3?
    Step1.Type <Sw-AC3#show vlan.This will display list of vlans and associated port.Based on the vlan no find out the default gateway (i.e interface ip address of VLAN-R1 router corresponding to that vlan)
    -----------------------------------------------------------------------------------------------------------------------------
    Q9. Out of which ports will frame with source mac-address 0010.5a0c.A086 and destination mac address 000a.8a47.0612 be forwarded (choose two)
    Step1.Type <Sw-AC3# show mac-address-table.

    Step2.In the output check if the 2 mac addresses mentioned above have been learnt by the switch.If they are not then it will be flooded out on

    all ports except the port on which it was recd (the port coressponding to source mac).If dest mac is present in the table it will be sent out on the port on which the address was learnt(port coresponding to the address in the output of show command)


    -----------------------------------------------------------------------------------------------------------------------------

    Q 10.From which switch did Sw-AC3 receive the VLAN information?

    Step1.Type <Sw-AC3#show vtp status>

    Step2.The VTP message contains updater identity i.e one who has last updated the vlan config info.The IP address of the updater will be displayed at the bottom i.e the updater of vlan info along with the time when it updated.It could also be Sw-AC3 itself.In that case the updater identity will indicate as local.

    Step3.Now type <Sw-AC#show cdp neighbor detail.This will provide the hostname corressponding to that IP.

  3. #3
    عضو
    تاريخ التسجيل
    Oct 2006
    المشاركات
    122
    الدولة: Egypt
    معدل تقييم المستوى
    0

    مشاركة: سؤال 44 في p4s لاهل الخبرة

    انا معاك في الاجابات اللي انت قلتها وهي معايا فعلا
    بس اللي دهشني ان الاجابات دي الحل بتاعها في ال p4s محلوله غلط

  4. #4
    عضو
    تاريخ التسجيل
    Sep 2005
    المشاركات
    58
    معدل تقييم المستوى
    0

    رد: سؤال 44 في p4s لاهل الخبرة

    اخي العزيز لا تستطيع معرفه ان كانت الاجابات صحيحيه او لا في الباسفورشور لان يجب اولا ان تطبق الاومر في الخطوات السابقه علي كل سؤال حسب طلبه ومن خلال output من هذه الاوامر بعد تطبيقه علي السويتش تستطيع عنده معرفة الاجابه الصحيحه

    وبالتوفيق

  5. #5
    عضو
    تاريخ التسجيل
    Feb 2006
    المشاركات
    101
    الدولة: Kuwait
    معدل تقييم المستوى
    0

    مشاركة: سؤال 44 في p4s لاهل الخبرة

    الطريقة التي ذكرها الاخ من قبلي هي امثل طريقة لحل مثل تلك الاسالة
    اما بالنسبة ل الباسفور شور فالاجابات تعتمد على السؤال نفسه ولهذا يجب عليك تطبيق الاوامر وترى الاجابة فهذه هي الطريقة الصحيحة . فقد تكون الاجابات مختلفة من سؤال لسؤال فلا تعتمد على الاجابات لسؤال واحد فقط انما اعتمد على الأوامر وكيفية تطبيقها

  6. #6
    عضو
    تاريخ التسجيل
    Oct 2006
    المشاركات
    122
    الدولة: Egypt
    معدل تقييم المستوى
    0

    مشاركة: سؤال 44 في p4s لاهل الخبرة

    اقتباس المشاركة الأصلية كتبت بواسطة rawad_g مشاهدة المشاركة
    الطريقة التي ذكرها الاخ من قبلي هي امثل طريقة لحل مثل تلك الاسالة
    اما بالنسبة ل الباسفور شور فالاجابات تعتمد على السؤال نفسه ولهذا يجب عليك تطبيق الاوامر وترى الاجابة فهذه هي الطريقة الصحيحة . فقد تكون الاجابات مختلفة من سؤال لسؤال فلا تعتمد على الاجابات لسؤال واحد فقط انما اعتمد على الأوامر وكيفية تطبيقها

    شكرا علي المداخلة
    ربنا يكرم الجميع

  7. #7
    عضو
    تاريخ التسجيل
    Sep 2006
    المشاركات
    88
    الدولة: Egypt
    معدل تقييم المستوى
    0

    مشاركة: سؤال 44 في p4s لاهل الخبرة

    انا اسف جدا جدا والله غصب عنى انى اتاخرت عليك وانت ماقولتليش ان امتحانك قريب كده انت عارف ان الهارد بتاعى اتحرق ومقدرتش اجيب هارد تانى
    بالنسبه للسؤال ده مش هييجى نهائى انشاء الله وعلى ضمانتى هو وسؤال ospf ركز فى باقى الاسئله وعلى فكره انا شايف ان p4sure اتغير ياريت تاجل الامتحان وتشوفه يكون افضل وطمنى واسف مره تانيه على التاخير

  8. #8
    عضو
    تاريخ التسجيل
    Oct 2006
    المشاركات
    122
    الدولة: Egypt
    معدل تقييم المستوى
    0

    مشاركة: سؤال 44 في p4s لاهل الخبرة

    اقتباس المشاركة الأصلية كتبت بواسطة bakar2006 مشاهدة المشاركة
    انا اسف جدا جدا والله غصب عنى انى اتاخرت عليك وانت ماقولتليش ان امتحانك قريب كده انت عارف ان الهارد بتاعى اتحرق ومقدرتش اجيب هارد تانى
    بالنسبه للسؤال ده مش هييجى نهائى انشاء الله وعلى ضمانتى هو وسؤال ospf ركز فى باقى الاسئله وعلى فكره انا شايف ان p4sure اتغير ياريت تاجل الامتحان وتشوفه يكون افضل وطمنى واسف مره تانيه على التاخير

    ولا يهمك يابيه
    انا الحمد لله فهمته ومركز وواخد بالي
    من تغير ال pass4sure
    وان شاء الله هبقي اطمنك خير ان شاء الله

المواضيع المتشابهه

  1. سؤال لاهل الخبرة
    بواسطة kokoz في المنتدى منتدى الشهادات العام
    مشاركات: 1
    آخر مشاركة: 31-01-2012, 14:20
  2. سؤال لاهل الخبرة
    بواسطة osamasamir في المنتدى الأرشيف
    مشاركات: 1
    آخر مشاركة: 18-05-2009, 12:13
  3. سؤال لاهل الخبرة
    بواسطة yazan anwar في المنتدى السوفتوير العام
    مشاركات: 2
    آخر مشاركة: 31-03-2009, 23:16
  4. سؤال لاهل الخبرة
    بواسطة abu_basil في المنتدى الأرشيف
    مشاركات: 1
    آخر مشاركة: 01-05-2006, 18:51
  5. سؤال لاهل الخبرة..؟؟
    بواسطة islamic في المنتدى الأرشيف
    مشاركات: 15
    آخر مشاركة: 16-12-2003, 10:39

الكلمات الدلالية لهذا الموضوع

المفضلات

ضوابط المشاركة

  • لا تستطيع إضافة مواضيع جديدة
  • لا تستطيع الرد على المواضيع
  • لا تستطيع إرفاق ملفات
  • لا تستطيع تعديل مشاركاتك
  •