اى لي صديق بجهازة كانت فية مشكلة كل ما يصلحه المحلا يجلس
شهر ويخرب ما ابغ مشكلة للخراب
الغريبة انه لوحة الام فيها اربع منافذ لرامات sdr&ddr
سارفق الجزء الخاص بالرامات من الكتاب الخاص بالجهاز
المشكلة ان الرامات عنده 64 من النوع القديم طبعا بالمنفذ القديم
رحت ابغ اركب 512 في المنافذ الحديثة ظهر الشاشة بال
المهم ركبناها وشلنا القديمة
شغلنا الجهاز اشتغل بس الشاشة تعطينا لمبة حمراء وماتظهر شي على الجهاز
ايش المشكلة تتوقعون
وهذا الجزء الخاص بالرامات
Memory Support
• Two 168-pin DIMM slots for SDRAM memory modules
• Two 184-pin DIMM slots for DDR memory modules
• Support SDRAM up to 100 MHz /DDR up to 200 MHz memory bus
• Maximum installed memory is 1GB
Notice: You can NOT use SDRAM and DDR simultaneously.
وهذا ايضا
Install Memory
The mainboard has two 168-pin/184-pin DIMM sockets for SDRAM/DDR (Double Data Rate) SDRAM system memory modules. You must install at least one memory module in order to work out the mainboard, either SDRAM or DDR SDRAM, but you can not use them simultaneously.
DDR SDRAM provides 800 MB/s or 1 GB/s data transfer rate corresponding with the bus 100 MHz or 200 MHz. It doubles the rate to 1.6 GB/s and 2.1 GB/s by transferring data on both the rising and falling edges of the clock. DDR SDRAM uses additional power and ground lines and requires 184-pin 2.5V unbuffered DIMM module reather than the 168-pin 3.3V unbuffered DIMMs used by SDRAM.
For this mainboard, the maximum memory size is 1GB.
The edge connectors on the memory modules have cut outs, coinciding with spacers in the DIMM sockets that can only install the memory module in the correct orientation.
To install a module, push the retaining latches at either end of the socket outwards. Position the memory module correctly and insert it into the DIMM socket. Press the module down into the socket so that the retaining latches rotate up and secure the module in place by fitting into notches on the edge of the module.
المفضلات