لو عايز تشتغل على sdm من غير ما يكون عندك راوتر حقيقي استعمل الملف التالي:
Cisco SDM Simulator
https://cisco-egypt.com/tags/SDM/default.aspx
طريقة التشغيل:
Install and Run the SDM Demo Application
[LIST][*]Extract the zip file SDM_demo_tool.zip.[/LIST]
[LIST][*]Copy the 'dataFile.zip' to C:\[/LIST]
[LIST][*]Have latest SDM2.3.2 build installed in your PC. If you do not have the SDM2.3.2 installed, you could get the build from the location
https://www.cisco.com/pcgi-bin/tablebuild.pl/sdm[/LIST]
[LIST][*]When SDM is installed on a PC , Internet Explorer may displayHTML source code when you attempt to launch SDM. To fix this problem, go to Tools > InternetOptions > Advanced. Then scroll to the Security section, check Allow active content to run in files onmy computer, and click Apply. Then relaunch SDM.[/LIST]
[LIST][*]Click on the Cisco SDM icon on your desktop to launch the SDM demo version. Enter the loopback address 127.0.0.1 and click on the launch button to start the SDM demo application. Accept any security certificate notification messages that pop up.[/LIST]
[LIST][*]Use the ca.cer and router.cer certificates to demonstrate importing Certificate Authority (CA) and Router certificates. You could get these certificates from SDM_demo_tool.zip.[/LIST]
Caveats
Following features are currently not fully supported on the demo application even though they show up on the SDM user interface -
a. SDM Updates
b. Reset to Factory
c. File Management
d. Management access
e. Troubleshooting
f. CLI Views
g. IPS – Edit IPS signatures, SDEE messages
h. VPN – PKI enrollment wizard
i. WebVPN – Installing svc and csd application
j. Config Editor
k. Secure Device Provisioning (SDP)
l. Router Provisioning
ضوابط المشاركة
المفضلات