1- Refer to the exhibit. The network administrator needs to setup Switch1 for remote access from HostA.
The show ip interface brief is issued on Router1 and the show interfaces trunk command is
issued on the Switch1 to verify the current status. The administrator applies the additional
configuration shown in the exhibit to Switch1. However, the telnet from HostA fails. What additional
commands need to be applied to the switch?

Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.1.1.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254


Switch(config)# interface vlan 1
Switch(config-if)# ip address 10.1.50.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.50.254


Switch(config)# interface vlan 10
Switch(config-if)# ip address 10.1.10.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254


Switch(config)# interface vlan 10
Switch(config-if)# ip address 10.1.1.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254


Switch(config)# interface vlan 50
Switch(config-if)# ip address 10.1.10.250 255.255.255.0
Switch(config-if)# no shutdown
Switch(config-if)# ip default-gateway 10.1.10.254

**

2-


**


3- Refer to the exhibit. Which two facts can be confirmed by this output? (Choose two.)

This switch shows no configuration revision errors.
This switch has established two-way communication with the neighboring devices.
This switch is configured to advertise its VLAN configuration to other VTP-enabled switches in the same VTP domain.
This switch will drop all VTP advertisements that come from the switches that are configured in the same VTP domain.
This switch will cause no disruption in the VTP domain operations if the rest of the switches in the same VTP domain have a higher configuration revision number.


**

4- Refer to the exhibit. Which two statements are true regarding what the cost value of 23 represents
for Switch4? (Choose two.)

This cost represents the lowest cost path for Switch4 to the root switch.
A cost of 23 is the value being advertised out port 16 on the switch upstream (closer) to the root switch.
Switch4 adds the cost of a Fast Ethernet link to 23 to determine its total cost to reach the root switch.
Switch4 is connected via a Fast Ethernet link to an upstream switch that in turn is directly connected to the root switch via a Gigabit Ethernet link.
The root switch is advertising a cost of 23, which is lower than any other switch in the VLAN0001 spanning-tree domain.


**


5- Refer to the exhibit. What does "FORWARDING" mean in the command output shown?
The switch is sending and receiving data frames.
The switch is receiving BPDUs, but not sending data frames.
The switch is participating in an election process by forwarding the BPDUs it receives.
The switch is receiving BPDUs and populating the MAC address table, but not sending data.


**

6-


**

7-


**

8-


**

9-


**

10-


**

11-


**
my answers

1- c

2- d

3- a,c

4- a,b

5- a

6- a,c

7- b

8- a,c,f

9- b

10- a,e,f

11- b