جزاك الله خيرًا أخي سيسكاوي على هذا الرد وحرصك على رؤيتي للإجابة
بالنسبة للسؤال الثاني لا خلاف عليه .
بالنسبة للسؤال الأول : انظر إلى هذا الكلام
The BPDU filtering feature can be globally enabled on the switch or can be enabled per interface, but
the feature operates with some differences.
At the global level, you can enable BPDU filtering on Port Fast-enabled interfaces by using the
spanning-tree portfast bpdufilter default global configuration command. This command prevents
interfaces that are in a Port Fast-operational state from sending or receiving BPDUs. The interfaces still
send a few BPDUs at link-up before the switch begins to filter outbound BPDUs. You should globally
enable BPDU filtering on a switch so that hosts connected to these interfaces do not receive BPDUs. If
a BPDU is received on a Port Fast-enabled interface, the interface loses its Port Fast-operational status,
and BPDU filtering is disabled.
At the interface level, you can enable BPDU filtering on any interface by using the spanning-tree
bpdufilter enable interface configuration command without also enabling the Port Fast feature. This
command prevents the interface from sending or receiving BPDUs.
Caution Enabling BPDU filtering on an interface is the same as disabling spanning tree on it and can result in
spanning-tree loops.
You can enable the BPDU filtering feature for the entire switch or for an interface
أليس معنى هذا الكلام أنه لا يلزم تفعيل الأمر على config mode
المفضلات