السلام عليكم ورحمة الله وبركاته
بغيت مساعده بسيطه في الاستقرار على 4000
مع العلم المعالج مستقر على الفولت ولكن الرام و الجسر غير مستقران
الاعدادات كالتالي:
Ai Overclock Tuner: Manual
OC From CPU Level Up: Auto
Ratio CMOS Settin 9
FSB Frequency: 445
CPU Clock Skew: Normal
NB Clock Skew: Normal
FSB Strap to North Bridge: 400
DRAM Frequency: DDR2-890MHz
DRAM Timing Control: Manual
1st Information:
CAS# Latency: 5 DRAM Clocks
DRAM RAS# to CAS# Delay:5 DRAM Clocks
DRAM RAS# Precharge: 5 DRAM Clocks
DRAM RAS# Activate to Precharge: 15 DRAM Clocks
RAS# to RAS# Delay: Auto
Row Refresh Recycle Time:auto
Write Recovery Time: Auto
Read to Precharge Time: Auto
2nd Information:
Read to Write Delay (S/D): Auto
Write to Read Delay (S): Auto
Write to Read Delay (D): Auto
Read to Read Delay (S): Auto
Read to Read Delay (D): Auto
Write to Write Delay (S): Auto
Write to Write Delay (D): Auto
3rd Information:
Write to PRE Delay: Auto
Read to PRE Delay: Auto
PRE to PRE Delay: Auto
All PRE to ACT Delay: Auto
All PRE to REF Delay: Auto
DRAM Static Read Control: Enabled
DRAM Read Trainin Auto
MEM. OC Charger: Auto
Ai Clock Twister: Strong
Ai Transaction Booster: auto
PCIE Frequency: 100
CPU Voltage: 1.33750
CPU PLL Voltage: 1.5
FSB Termination Voltage: 1.25
DRAM Voltage: 2.05
North Bridge Voltage: 1.29
South Bridge 1.5 Voltage: 1.50
South Bridge 1.1 Voltage: 1.10
CPU GTL Reference (0): +20mv
CPU GTL Reference (1):-15mv
CPU GTL Reference (2): +20mv
CPU GTL Reference (3): -15mv
NB GTL Reference: Auto
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto
CPU Configuration:
Ratio CMOS Settin 9
C1E Support: Disabled
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
عملت اختبار على small للمعالج لمدة ساعتين و كان الاختبار ناجح
ولكن عملت اختبار Blend
45 دقيقه توقف الاختبار و ظهر التالي
Torture Test ran 45 minutes 16 seconds - 1 errors, 0 warnings.
Execution halted.
مع العلم زودت فولت الرام الرام من 2,05 إلى 2,1 ولكن نفس الشي واعتقد المشكله من الجسر والناقل واعدادات اخرى اتمنى المساعده
بإنتظاركم
المفضلات