Task 1: IP Subnet Planning
You have been given an IP address block of 192.168.23.0 /24. You must provide for existing
networks as well as future growth.
Subnet assignments are:
•
1st subnet, existing student LAN (off of router R2-Central), up to 60 hosts;
•
2nd subnet, future student LAN, up to 28 hosts;
•
3rd subnet, existing ISP LAN, up to 12 hosts;
•
4th subnet, future ISP LAN, up to 6 hosts;
•
5th subnet, existing WAN, point-to-point link;
•
6th subnet, future WAN, point-to-point link;
•
7th subnet, future WAN, point-to-point link.
Interface IP addresses:
•
For the server, configure the second highest usable IP address on the existing ISP LAN
subnet.
•
For R1-ISP's Fa0/0 interface, configure the highest usable IP address on the existing ISP
LAN subnet.
•
For R1-ISP's S0/0/0 interface, configure the highest usable address on the existing WAN
subnet.
•
For R2-Central's S0/0/0 interface, use the lowest usable address on the existing WAN
subnet.
•
For R2-Central's Fa0/0 interface, use the highest usable address on the existing student
LAN subnet.
•
For hosts 1A and 1B, use the first 2 IP addresses (two lowest usable addresses) on the
existing student LAN subnet.
Additional configurations:
•
For PCs 1A and 1B, in addition to IP configuration, configure them to use DNS services.
•
For the server, enable DNS services, use the domain name eagle-server.example.com,
and enable HTTP services.
•
For R1-ISP router serial interface, you will need to set the clock rate (a timing mechanism
required on the DCE end of serial links) to 64000.
•
No clock rate is needed on the DTE side, in this case R2-Central's serial interface.
Task 2: Finish Building the Network in Packet Tracer.
Add cables where missing.
•
Connect a serial DCE cable to R1-ISP S0/0/0, with the other end to R2-Central S0/0/0.
•
Connect PC 1A to the first FastEthernet port on switch S1-Central.
•
Connect PC 1B to the second FastEthernet port on switch S1-Central.
•
Connect interface Fa0/0 on router R2-Central to the highest FastEthernet port on switch
S1-Central.
• For all devices, make sure the power is on to the device and the interfaces
اللى انا مش فهمة باللون الاحمر ارجو المساعدة اللب دة لازم اسلمة وانا فهمة مش عايز اسلمة ناقص 12%
وانا املى كبير فى مهندسين المنتدى
المفضلات