هذا سؤال اللاب كامل
10.7.1: Skills Integration Challenge-Network Planning and Interface Configuration
DeviceInterfaceIP AddressSubnet MaskDefault GatewayR1Fa0/0N/AS0/0/0S0/0/1R2Fa0/0N/AFa0/1S0/0/0S0/0/1R3Fa0/0N/AS0/0/0S0/0/1PC-1ANICPC-1BNICPC-1CNICEagle_ServerNIC
Learning Objectives:
Build the network topology
Plan the IP addresses
Configure router and PC interfaces
Test the network
Background:
Practice your network building, planning, and configuration skills. Device names and routing have already been configured.
Task 1: Build the network topology
Use the following chart, and the devices in the Device Pool, to create the topology.
Routers:
HostnameInterfaceConnects ToInterfaceR1Fa0/0SW-1Fa0/1R1S0/0/0 (DCE)R2S0/0/0R1S0/0/1 (DCE)R3S0/0/1R2Fa0/0SW-2AFa0/1R2S0/0/1 (DCE)R3S0/0/0R2Fa0/1SW-2BFa0/1R3Fa0/0SW-3Fa0/1
Switches:
HostnameInterfaceConnects ToInterfaceSW-1Fa0/2PC-1AFastEthernetSW-2AFa0/2PC-1BFastEthernetSW-2BFa0/2Eagle_ServerFastEthernetSW-3Fa0/2PC-1CFastEthernet
Task 2: Create and assign an addressing scheme
You are asked to use the 192.168.1.0 /24 address space. Seven total networks are required; assign the networks in decreasing order of number of hosts required for efficient use of address space. Use the following charts to create an effective addressing scheme:
LAN:
HostnameInterfaceNumber of HostsR1Fa0/060R2Fa0/010Fa0/125R3Fa0/07
WAN:
WAN LinksAddress to be AssignedNumber of HostsR1-R2R1-First host address2R1-R3R1-First host address2R2-R3R2-First host address2
Use the following rules to assign the IP addresses.
PC's will use the first host address in the subnet.
The server will use the second to last host address in its subnet.
All FastEthernet ports on a router will use the last host address of the assigned subnet.
The R1-R2 link will use the first WAN subnet, with R1 using the first usable address and R2 using the last usable address.
The R1-R3 link will use the second WAN subnet, with R1 using the first usable address and R3 using the last usable address.
The R2-R3 link will use the third WAN subnet, with R2 using the first usable address and R3 using the last usable address.
DCE interfaces should have clock rates of 56000.
Task 3: Interface Configuration
Perform interface configuration of the R1, R2, and R3 routers, the PCs, and the server according to the addressing scheme above.
Task 4: Testing Connectivity
Make sure all PCs can ping their gateways, other PCs, and the server.
بانتظار احد يشرح لي ..كيف اطلع الأيبي والسب نت حق كل جهاز انا عملت خطوة التوصيل..
المفضلات