الف مبروك والى الامام
بالتوفيق
احمد الله على فضله اليوم نجحت بامتحان ccna وحصلت على 962 درجة
الاسئلة في الغالب كانت من testking 89
الsimul كان من ospf ايضا السؤال المتعدد vlan+vtp الموجود في التست كنغ 89
واسئلة اخرى معظمها عن السوتشات ايضا 3 اسئلة عن access list
[nat
وعقبال بقية الاخوان
اخوكم ابراهيم
الف مبروك والى الامام
بالتوفيق
TaKe a Massive Step
ألف ألف مبروك
ألف مبارك يا أخي
يا تري أي منهج اعتمدت عليه ؟؟؟؟
وشكرا
أخوك
خالد
الف مبروك
وفقك الله تعالى
[B][COLOR="blue"][CENTER]تكلم وأنت غاضب .. فستقول أعظم حديث تندم عليه طوال حياتك[/CENTER][/COLOR][/B]
الف الف الف مبروك ........... عقبالي امتحاني بعد اربعة او خمسة ايام انشاء الله....احتاج دعواتكم
اخوك طلال من العراق
الف مبروك و عقبال الجميع يارب.
لكن عندي استفسار في التيست كينج في سؤال متكرر ثلاث مرات وكل مره له اجابه مختلفه فما الحل؟
السؤال عن ال vlan
وهو موجود في 202 -- 212 -- 188 pages
in version 89 & 90
ارجو الرد بسرعه وجزاك الله خيرا
الاخوة الاعزاء اشكركم على حسن مشاعركم
اعتمدت على sybex 5 والتست كنج وخاصة الاصدار 89 كان معظم الاسئلة منه تحديدا الجزء الاخير
اما سؤال الاخ عن سؤال vlan+vtp
فان استخدام الاجابات التالية ومعها توضيح اوامر الاظهار المناسبة لكل حالة تفيد المطلوب
Q.1.What happens when SwX is reconnected to the network and a trunk exists between the two switches?
Step 1.Issue the Sw-AC3#show vtp status command.Note the domain name.The domain name of the 2 switches must be the same for them to
exchange vtp messages
Step2:If the domain name is the same,note the config rev no of Sw-AC3 and compare with that of Sw-X.Whichever switch has higher config
revision no. will be the vtp updater.Say Sw-X has higher rev no.Its vlan will replace that of Sw-AC3.
-----------------------------------------------------------------------------------------------------------------------------
Q2.What interface did switch AC-3 associate with Mac address 0010.5a0c.ffba?
Step1.Type in the command <SW-AC3#show mac-address-table.This will give you the port on which the MAC address was leant by this switch
-----------------------------------------------------------------------------------------------------------------------------
Q3.To which port of Sw-Ac3 is router VLAN-R1 connected?
Step1.Type <Sw-Ac3#show cdp neighbor detail.This will provide the details of VLAN-R1 i.e. hostname,IP address,and IOS version.
Step2:Type <Sw-AC3#cdp neighbor.This will display the port (local interface)on which R1 is connected.
-----------------------------------------------------------------------------------------------------------------------------
Q4.What ports of switch Sw-Ac3 are operationg as trunks?
Step 1.Type <Sw-Ac3#show interfaces trunk.This will display all the trunk ports.eg
Sw-AC3# show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 on 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-2
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-2
-----------------------------------------------------------------------------------------------------------------------------
Q5.Which switch is the root bridge?
Step1.Type <Sw-Ac3#show spanning-tree.This will give the MAC address of root bridge
Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)
Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2
----------------------------------------------------------------------------------------------------------------------------
Q6.out of which port on Sw-Ac3 will an IP packet with destination address not on local LAN be forwarded.
Step1.The packet will be sent to the default-gateway.Hence type <Sw-Ac3#show running-config.Note the IP address of the default-gateway.
Step2.Now type <Sw-AC3#show cdp neighbor detail.This will provide ip address mapping to hostname.
Step 3:Type <Sw-AC3#show cdp neighbor.This will give the local interface associated with the hostname.
-----------------------------------------------------------------------------------------------------------------------------
Q7.Which Which switch is the root bridge for vlan 1?
Step 1.Type <Sw-AC3#show spanning-tree vlan 1>This will give the MAC address of root bridge
Step2;Now type show mac-address-table.Note down associated interface with mac address of the root bridge (say fa 0/2)
Step3.Now type <Sw-AC3#show cdp neighbor.This will give the hostname of the switch connected on that port 91.e fa 0/2
-----------------------------------------------------------------------------------------------------------------------------
Q8.What address should be configured as the default-gateway for the host connected to
interface Fa0/4 of Sw-AC3?
Step1.Type <Sw-AC3#show vlan.This will display list of vlans and associated port.Based on the vlan no find out the default gateway (i.e
interface ip address of VLAN-R1 router corresponding to that vlan
-----------------------------------------------------------------------------------------------------------------------------
Q9. Out of which ports will frame with source mac-address 0010.5a0c.A086 and destination mac address 000a.8a47.0612 be forwarded (choose two)
Step1.Type <Sw-AC3# show mac-address-table.
Step2.In the output check if the 2 mac addresses mentioned above have been learnt by the switch.If they are not then it will be flooded out on
all ports except the port on which it was recd (the port coressponding to source mac).If dest mac is present in the table it will be sent out on
the port on which the address was learnt(port coresponding to the address in the output of show command)
-----------------------------------------------------------------------------------------------------------------------------
Q 10.From which switch did Sw-AC3 receive the VLAN information?
Step1.Type <Sw-AC3#show vtp status>
Step2.The VTP message contains updater identity i.e one who has last updated the vlan config info.The IP address of the updater will be
displayed at the bottom i.e the updater of vlan info along with the time when it updated.It could also be Sw-AC3 itself.In that case the
updater identity will indicate as local.
Step3.Now type <Sw-AC#show cdp neighbor detail.This will provide the hostname corressponding to that IP.
نعم يا اخي العزيز eng.nour اريد منك ان تقرا السؤالين جيدا ستلاحظ الاختلاف انا ايضا وقت في هذه المشكلة و لكن اقرا السؤال جيدا ستلاحظ انه ليس نفس السؤال هناك فرق بسيط بينهم و معك حق فان السؤال يبدو نفسه و الاجابات نفس الاجابات
و لكن هناك فرق .....
اخوك طلال من العراق
الف مبروك وادعولي امتحاني يوم السبت ب 25/3/2006
والله خايف منو
جزاك الله خيرا يا أخ طلال , لقد أعدت القرأة مره اخرى واكتشفت الفرق بين الحالتين فعلا , شكرا جزيلا
لا شكر على واجب اخي العزيز eng.nour و اتمنى لك التوفيق من كل قلبي
اخوك طلال من العراق
الف الف مبروك اخي وعقبال كل الشهادات.. بس انا لحظت ان بعد ما يحصل الواحد على شهادة CCNA تنقطع اخبار اكتر الشباب يعني مافي تفاعل لشهادة CCNP ، اريد اسال هل شهادة CCNA تكفي فقط ، وين الشباب ليش التوقف الى هدا الشهادة بس.!!؟؟؟
السلام عليكم ورحمة الله
كان ليه سؤال عن طبيعة الاسئلة الاختيارمن متعدد هل بتكون مفتوحه؟
"select all that applay" ولا بيكون محدد رقم معين؟
وكمان في ال simulation هل ال ؟ كـــ help شغاله
وهل لازم اعمل wr mem
copy run start
شكرا جزيلا
ألف مليون مبروووووووك
https://www.nepro.jp/ciw/img/ciw_logo_associate.gifhttps://www.yellowdot.com.au/images/ciw_logo.gifhttps://www.3dtek.net/ciw_prof.gif
https://www.specialist.ru/MS/mcp_logo_small.gif https://www.azlantraining.com/uk/images/mcad-logo.gif https://www.azlantraining.com/uk/images/mcsd-logo.gif https://www.cet.co.yu/pics/MCDST_logo.gifhttps://www.veiled-chameleon.com/ima...i-net-plus.jpg
https://www.teknimedia.com/assets/images/IC3-Logo.jpghttps://www.learningfast.com.au/_ass.../logo-icdl.gif
https://www.uplod.yaglby.com/files/Movoo-1145965169.gif
https://www.uplod.yaglby.com/files/Movoo-1147321393.gif
https://altlagee.com/upload/upload/ACE_Premiere.gif
https://altlagee.com/upload/upload/ACE_Generic.gif
https://www.uplod.yaglby.com/files/Movoo-1146053523.jpg
https://altlagee.com/upload/upload/mmmm.jpg
https://www.uplod.yaglby.com/files/Movoo-1147321380.gif
https://www.alphaware.net/images_oth...s/CEH_logo.gif
المفضلات