السلام عليكم
اذا ما عندك مشاكل باللوحة الام
ما انصحك تطور البايوس لانه العمليه فيها مخاطره
السلام على............... اهل المنتدي
ياشباب عندي مزر acorp واريد ان احدث bios لها
قمت بانزال الملفات الازمه من الموقع
www.acorp.com.tw
وهو خاص بالمزر
ولكن لا اعرف كيف اطور bios
ياريت ياشباب احد يكون عنده خبره ويدلنىعلى الطريق
جزاكم الله كل خير
شكرا للدخول
السلام عليكم
اذا ما عندك مشاكل باللوحة الام
ما انصحك تطور البايوس لانه العمليه فيها مخاطره
[B]Patience is the best medicine for life[/B]
أنور بوثنتين
عند مشكله هي
اني جبت هارد 40ووجت بعد ان المزر لا تراه
وعند السؤال عن السبب
كان السبب هو bios
لذلك اريد تطويره
شكرا على الدخول
بسم الله الرحمن الرحيم
الملف الذى انزلته اخى من موقع Acorp هو عبارة عن ملف exe. شغله اخى وفك ضغط الملفات الموجودة به واكتب لنا اسمائها.
[IMG]https://alwaleed11.jeeran.com/alwaleed.jpg[/IMG]
وفر لنا اسم المذربورد لنساعدك في تركيب الهاردسك دون ترقية للبيوس اذا استطعنا
السلام عليكم
قامى الموقع بانزال 3 مالفات هي(6bx812D.BIN، 6bx811b.bin)
وذلك بعد فك الملفات التي امتدادها *.exe
والملف الثالث هو شرح لم افهمه
وهو كما يالي:
This file contains information on the AWDFLASH BIOS utility
================================================== ========================
-> Flash EPROM provides you a convenient way to update your system BIOS
please note that updating your system BIOS is serious, only update when
you need to do it. Unnecessary updating can cause damage to the system
which will not be covered under the warranty.
-> If you update an incorrect file to your FLASH EPROM, the system may no
longer boot, please carefully follow the procedures in the manual or
ask a qualified technician and/or call your dealer.
--------------------------------------------------------------------------
Flash EPROM updating procedures:
--------------------------------------------------------------------------
1. Make sure the system is running in real mode. This utility will not
operate if the system is under protected mode or virtual mode. This
means that you cannot reprogram the motherboard BIOS under the Windows
environment or with any memory management software, including HIMEM.SYS.
The following describes the easiest way run your system from real mode:
1) Boot from a floppy disk formatted with the "FORMAT A:/S" command
without creating CONFIG.SYS and AUTOEXEC.BAT files.
2) If you are using MS-DOS 6.x, you can bypass the AUTOEXEC.BAT and
CONFIG.SYS by pressing <F5> when "Starting MS-DOS... " line is
displayed on the screen.
3) For Windows 95/98 users, press <F8> to enter the Microsoft Windows
95/98 Startup Menu and then choose "Safe mode command prompt only"
You should save the download files to your hard disk drive. Once you have
accomplished the above tasks, you can run the Flash Memory Writer utility.
To run the utility, change to the directory containing AWDFLASH.EXE and
then at the DOS prompt, type: [AWDFLASH] <Enter>
--------------------------------------------------------------------------
IMPORTANT PROCEDURE:
--------------------
1. Save Current BIOS to File (Perform upon first use of your system)
This option allows you to copy the contents of the Flash memory chip into
a file in the disk. This gives you a backup copy of the original motherboard
BIOS in case you need to re-install it. In such cases where the data on the
chip get lost or corrupted, you can reprogram the chip using this backup copy.
If you encounter problems while downloading the new BIOS, DO NOT turn off
your system since this might prevent your system from booting up. Just
repeat the process, and if the problem still persists, download the
original BIOS file you created in step 1 above.
2. After successfully downloading the new BIOS file, exit the Flash
Memory Writer utility and then turn off your system.
3. Turn on the system and hold down <DEL> to enter BIOS Setup. You must
load "Setup Default" to affect the new BIOS.
-------------------------------------------------------------------------
WARNING:
---------
If the Flash Memory Writer utility was not able to successfully download
a complete BIOS file, your system may not be able to boot up.
If this happens, your system will require service from your vendor.
انا لم افهم الطريقه الموضحه هنا
شكرن على الردود التى قمتم بها
اسف ياشباب
على كتابت الغه الانجليزيه
لاني قد قمت بعمل copy لها
بسم الله الرحمن الرحيم
عجيبة ، لم يوجد ملفين للبيوس؟
ماهو موديل اللوحة الام التى لديك؟ هل هو 6BX82 او 6BX83 ؟
[IMG]https://alwaleed11.jeeran.com/alwaleed.jpg[/IMG]
يوجد برنامج منهم وهو 6BX83
وهو برنامج flash الذي يساعد في عمليه التطوير
بسم الله الرحمن الرحيم
اخى، لقد ذكرت لى ملفين وكلاهما بامتداد BIN وهذا الامتداد هو لملف البيوس. برنامج الترقية من FLASH ياتى بامتداد EXE ويكون اسمه AWDFLASH.EXE او اسم مقارب من هذا.
اللوحة الام التى لديك هل هى 6BX83؟ اريد ان احمل الملف من موقع الشركة لكى ارى بنفسى ماهى الملفات الموجودة به.
[IMG]https://alwaleed11.jeeran.com/alwaleed.jpg[/IMG]
موقع الشركه الذي حملت منه الملفات هو
https://www.acorp.com.tw/English/default.asp
اشكرك اخي.........الوليد
علي الاهتمام
ثم ادخل
download centet
ثم اختار
BIOS Upgreade
وهنال تجد جميع الاصدارات للمزر acorp وتطويرها
بسم الله الرحمن الرحيم
اعلم بموقع الشركة اخى وكيف اصل للملف. ولكنى بحاجة معرفة اى لوحة ام لديك. لديهم لوحتين مشابهتين للوحة التى لديك. احدهما هى 6BX82 والاخرى 6BX83. كل واحدة منها لها بيوس مختلف عن الاخرى. حد لى اخى اى لوحة منها لديك.
[IMG]https://alwaleed11.jeeran.com/alwaleed.jpg[/IMG]
اخي الوليد
حدث عندي خطا في فهم الموقع
لقد تصورت ان هذه هى برامج (AWDFLASH.EXE )
اما المزر بتاعتي هي 6BX86
ولا اعرف ماهو برنامج flash الخاص بل مزر
وكيف احصل عليه
شكرا على المساعده
واعلم اني اجهتك لعدم فهمي
يوجد في الموقع للمزر بتعتي ver:C و ver:2D
ايهما اختار
مع العلم ان المزر تقرا ver :B
المفضلات