السلام عليكم
هذه هي الخطوات المطلوبة لربط ال sdm مع برنامج ال dynamips
هذا الموضوع منقول ولكن لغرض الافادة
الخطوات
How to configure SDM with Dynamips
mars 2, 2008 — niamor
Hello gears,
I installed SDM engine today in order to prepare myself for ISCW test.
I searched the web about howto’s but I never found what I needed. Hope that tutorial can help someone else.
Steps :
Configure an ip address on a router interface and enable it. This interface must be fast/ethernet type.
Ex :
Router#conf t
Router(config)#ip http secure-server (Some keys should be generated…)
Router(config)#interface fastethernet0/0
Router(config-int)#ip address 172.16.0.2
Router(config-int)#duplex full
Router(config-int)#no shut
Install a loopback adaptater on your pc : You can follow the following article for this Link.
Run the “Network device list” batch from Dynamips folder and gather the hardware reference for your network adaptater.
Edit you .net file and add the following statement
F0/0 = NIO_gen_eth:DeviceNPF_{ ** your nic reference **}
Modify the new Windows network connection and assign it a static ip address such as 172.16.0.1/24.
Run your .net file and try to ping from both sides : Router->PC and PC->Router
Install SDM engine on your PC. I’m currently using the version 2.4.1. You may need to allow activex, you can trust them.
Use the ip address you defined on the router and enter it into SDM. 172.16.0.2 in our case.
You will be prompted for a username and a password. You have to define it into router configuration. Below is an example.
Router(config)#usernmame sdm priv 15 password sdmlab
المفضلات